GSO ISO 21105-1:2022

Gulf Standard   Current Edition
· Approved on 12 May 2022 ·

Performance of buildings — Building enclosure thermal performance verification and commissioning — Part 1: General requirements

Thermal insulation of buildings
Including energy efficiency of buildings

GSO ISO 21105-1:2022 Files

GSO ISO 21105-1:2022 Scope

This document describes a building enclosure commissioning process to achieve a well performing, durable and maintainable building enclosure. This document includes procedures, methods and documentation requirements describing the application of the commissioning process to a building enclosure at each phase of a project. These project phases span from predesign through owner occupancy and operation. This process is referred to throughout this document as building enclosure commissioning (BECx).

This document applies to new building construction and building re-commissioning. This document is for use by an owner, commissioning provider, building developer, owner's representative, construction manager, architect, contractor, and/or consultant, etc. Its purpose is to determine and complete the required tasks and activities to deliver a building enclosure which meets the performance requirements of the owner. Requirements for the project are established by the owner and/or commissioning provider (CxP).

This document identifies steps necessary to perform a building enclosure risk analysis. The analysis will result in tasks that define the level of BECx, commensurate with the owner's tolerance for risk associated with building enclosure performance.

The BECx process covered by this document is applicable to an individual assembly, a combination of assemblies or a whole enclosure assembly. For example, an individual assembly can be the fenestration, the air barrier or the thermal insulation. A combination of assemblies would include the fenestration, the air barrier and the complete heat transfer system, (e.g. both the insulation and roof assembly). A whole building enclosure assembly would include all heat, air and moisture control layers of the building enclosure, on all six sides of the building.

This document describes requirements for any third-party consultants and/or building enclosure commissioning providers (BECxP) to document their technical qualifications, independence and knowledge of the BECx process, including their education, training, and experience.

Best Sellers From Construction and Building Sector

GSO 1431:2002
 
Gulf Technical Regulation
Sanitary appliances - pressurized flushing devices
OS GSO 1431:2002
GSO 1431:2002 
Omani Standard
Sanitary appliances - pressurized flushing devices
GSO 1427:2008
 
Gulf Standard
Ceramic Sanitary Appliances - Western Water Closets
OS GSO 1427:2008
GSO 1427:2008 
Omani Standard
Ceramic Sanitary Appliances - Western Water Closets

Recently Published from Construction and Building Sector

GSO EN 1097-3:2024
EN 1097-3:1998 
Gulf Standard
Tests for mechanical and physical properties of aggregates - Part 3: Determination of loose bulk density and voids
GSO ASTM C926:2024
ASTM C926:23a 
Gulf Standard
Standard Specification for Application of Portland Cement-Based Plaster
GSO ASTM E2129:2024
ASTM E2129:18 
Gulf Standard
Standard Practice for Data Collection for Sustainability Assessment of Building Products
GSO EN 196-3:2024
EN 196-3:2016 
Gulf Standard
Methods of testing cement - Part 3: Determination of setting times and soundness